Home » Belts » Corexy Belt Path

Corexy Belt Path

03/08/2018 In corexy mechanisms, when you apply force to one belt (move one of the motors in the Y direction, for example) to change its tension, you also change the tension on the other belt.

When you assemble the mechanism and adjust tension on the first belt , #, CoreXY Belt Path.

The corexy 3d printer belt path has been explored in many mechanical arrangements.

The main two corexy belt routing methods are belts crossed or not crossed.

The main focus should be to keep the belt routing path parallel to the X and Y guide rails.

There#s an excellent blog about corexy belt path by Mark Rehorst here.

14/04/2019 CoreXY cross belt path.

Posted by mogey336.

Forum List Message List New Topic.

mogey336.

CoreXY cross belt path April 14, 2019 05:38PM Registered: 4 years ago Posts: 22 I need help for COREXY belt path.

I know that the green belt is higher than the red belt Can i make the belt at the gantry X (the two pulleys at the left and right) the same.

9 rows The advantage of coreXY are discussed by some: There is two ways to built the CoreXY belt #, You can change the position of the idlers as long as you keep this to be true: The most important thing in any coreXY implementation is that the belt segments (a segment being the belt between two pulleys or between the extruder carriage and the end pulleys) whose length varies (labeled A-H in the diagram below), must be kept parallel to their respective guide rails.

11/04/2019 # Motors physically separated from the XY belt path with closed belts and dampers.

An elegant way to suppress vibrations, put less force on motors shaft horizontally, move motors to printer#s back and allow to test XY belt path without motors.

# Easy belt tensioning mechanism # Very nice extruder (Mobius).

29/02/2016 The coreXY acts the same as the movement mechanism you mention, it just has a longer loop and is rotated 45 degrees.

The longer belt path #, CoreXY & Z system.

Bed assembly & heater.

ACM back panel.

5 Linear guides.

4 meter Gates 2GT open belt.

2 lead screws.

15 anodized aluminum brackets.

20 pulleys & gears.

700+ bolts, nuts, washers.

Well, it’s two years later and one of the so-called 20-year LED bulbs failed.

I wanted to replace both of them with yellow bulbs because the white light attracts bugs, and the bugs attract spiders, and the spiders make webs and catch the bugs and leave things looking very messy.

I found a couple candelabra base yellow LED bulbs at Home Depot, got out the ladder and went to install the new bulbs.

Workhorse at MRRF 2019 Machine Shop.

Welcome to 3D Distributed! We are a CNC machine shop in Conroe, TX.

We provide standard CNC machining services and corexy belt path